Read every source, reconcile to the bill, act on the peak.
Voltframe is read-only by design. We connect to what you already run, calibrate against the invoice, and hand back recommendations with payback attached.
Two of these move your peak. Most tools skip them.
Grid, solar and storage are table stakes. HVAC load and utility demand response are where the peak actually lives.
Interval data from utility meters and submeters, reconciled against the bill.
On-site generation, inverter-level, net of curtailment.
State of charge, dispatch windows and cycle cost.
Runtime and load from the building management system.
Utility event signals, forecast peaks and measured response.
Read-only integrations to the systems you already run.
BACnet and Modbus for the BMS, utility interval APIs and Green Button, inverter portals for solar, and battery controllers for storage. Nothing writes back to your equipment.
Every claim is reconciled to the invoice first.
We build a weather-normalized baseline and tie meter data back to the actual bill. If the numbers don’t match the invoice, we fix the model before we show you a savings figure.
Recommendations ranked by savings and effort.
Each recommendation carries an estimated payback and the source that drives it. After you act, we verify the result against the next bill and mark it delivered or not.
Built for operators and finance in the same view.
Live events
Utility DR signals, price spikes and load flags, with the action taken logged against each.
Bill-verified reports
Quarterly savings tied to the invoice, exportable for finance and board decks.
Portfolio roll-up
One number across every site, with drill-down to the meter behind it.
See it running on sample data.
The guided demo walks a real portfolio end to end — no account, no call required.